User's Manual

September, 2005 – Operators Manual
ENERNET Corporation
4
SEVEN-BUTTON CONFIGURATION
The seven-button T9000 thermostat provides programmable
functions. The user can set the clock and program the thermostat
to automatically set specified temperatures at specified times.
Figure 5 — Three-Button Cluster
PROGRAM:
Places the T9000 into program mode.
RUN:
Causes the T9000 to run or stop running its program.
CLOCK:
Places the T9000 into clock setup mode.
Figure 6 — Seven-Button LCD Display
Setting the Clock
As you adjust the clock and program your T9000, notice that the
display helps you by continuously blinking the item you are ready to
change. The UP and DOWN buttons change settings, the
HEAT/COOL button is used to ENTER or keep a change.
To set the clock, you will use the buttons marked CLOCK, UP,
DOWN, and HEAT/COOL.
STEP ONE:
Press the CLOCK Button. The hour digits will flash. Press the UP
or DOWN button to change to the proper hour. Note that AM / PM
will change as you roll the hour past 12. Be sure to set the hour
properly for AM or PM. Press the HEAT/COOL button to keep the
hour you've just set and to move to minutes.
STEP TWO:
The Minute digits will now be blinking. Press the UP or DOWN
button to change to the desired minute. When the correct minute is
flashing press HEAT/COOL.
STEP THREE:
One of the seven day icons (Mo, Tu, We, Th, Fr, Sa, Su) will now
flash. Press UP or DOWN until you see the current day icon
flashing. When the correct day is flashing press HEAT/COOL.
STEP FOUR
Press the CLOCK button to keep all clock changes you've made
and resume normal operation.
PROGRAM RUN CLOCK
Th
FAN AUTO
COOL
70
O
O
Current
Temperature
Mode of
Operation
Setpoint
Fan Status
11:20
AM
Day
Time & Day
Program Period
Set Point