User's Manual

September, 2005 – Operators Manual
ENERNET Corporation
5
PROGRAMMING YOUR THERMOSTAT
Your T9000 provides you with four program periods: Morning,
Day, Evening, and Night. You can set the time and temperature
of each period, corresponding to the time you wake-up, leave for
the day, return home, and sleep. For example:
PERIOD TIME TEMP.
MORNING 6:30 AM 70°
DAY 8:30 AM 64°
EVENING 4:15 PM 70°
NIGHT 11:30 PM 60°
The T9000 does not allow separate heating and cooling programs.
Whatever you program for times and temperatures will apply to
heating or cooling. Check the program when switching over from
heating to cooling and back. What is comfortable in the cooling
season may not be in the heating season. During summer months
for example, when air conditioning your home, an indoor air
temperature of 75º, or even warmer feels comfortable. However,
in the winter, 75º will likely feel too warm. You should check
your thermostat program seasonally and adjust as needed.
To program your thermostat, you will use the PROGRAM,
HEAT/COOL, UP, and DOWN buttons.
STEP ONE:
Press the PROGRAM button to put the thermostat into the
programming mode. The display will blink all of the day of the
week icons. Pressing the UP or DOWN button will toggle
between (weekday) icons and the (weekend) icons. Ensure the
display is blinking the one you want to program. Press
HEAT/COOL.
STEP TWO:
The Morning period will be blinking. Use the UP or DOWN
button to toggle through Morning, Day, Evening, or Night,
stopping at the period you want. Press HEAT/COOL.
STEP THREE:
Next, the hour of the day will blink on the display. This is the
starting hour of the period you have selected. Use the UP or
DOWN button to change the selected hour start time. Press
HEAT/COOL.
STEP FOUR:
The minute of the day will blink next. This is the starting minute
in the hour. Use the UP or DOWN button to change the minute
digits to the desired setting. (Note that minutes change in five-
minute increments.) Press HEAT/COOL.
STEP FIVE:
The desired set point will now be blinking. This is the temperature
you want the thermostat to bring the heated or cooled space to at
the time of day you have selected. Press the UP or DOWN button
to change the set point temperature to what you want. Press
HEAT/COOL.
This completes the programming of the first period of the day.