Owner`s manual
5. Combustion blower is not working properly.
Check if the blower is still working (separately – bypassing the control board). Make
sure that there is not any obstruction in the fresh air kit and into the air intake tube.
6. Bad pellets
(Applies to “GLASS SOOTS UP AT A VERY FAST RATE” Only)
The brand of pellets or the batch of pellets that are being used may be of poor quality.
If possible, try a different brand of pellets. You might also want to try a brand that is
made from a different type of wood (softwood vs. hardwood). Different woods have
different characteristics when being burned. Your pellets may also be too humid.
Make sure you store your fuel properly, in a dry ventilated area.
• The control board does not display any information.
The control board does not display any information.The control board does not display any information.
The control board does not display any information.
Possible Causes:
Possible Causes:Possible Causes:
Possible Causes:
Possible Remedies :
Possible Remedies :Possible Remedies :
Possible Remedies :
1. A fuse on the control board has blown.
Remove the control board. Check if the F7 fuse on the back of it appears to be bad.
Replace it with a 7.5 Amp 250 Volt fuse. Plug the stove back in and try to run the unit.
Possibles
PossiblesPossibles
Possibles
Causes
CausesCauses
Causes:
::
:
Possibles Solutions
Possibles SolutionsPossibles Solutions
Possibles Solutions:
::
:
Warning generated by a power failure while the stove was
running.
The stove will restart on the initial
setting once it cools off.
Note: For a short power failure (less than 5 seconds), the stove will continue to
function at the selected speed.
SMOKE SMELL OR SOOT BUILD
SMOKE SMELL OR SOOT BUILDSMOKE SMELL OR SOOT BUILD
SMOKE SMELL OR SOOT BUILD-
--
-UP
UPUP
UP
Because it is a pellet-burning device, your Euromax may emit a faint wood-burning odor. If this increases beyond normal,
or if you notice an unusual soot build-up on walls or furniture, check your exhaust system carefully for leaks. All joints
should be properly sealed. Also clean your stove, following instructions in “MAINTENANCE
MAINTENANCEMAINTENANCE
MAINTENANCE”. If problem persists, contact
your dealer.
5.
5.5.
5.
ELECTRICAL DIAGRAM
ELECTRICAL DIAGRAMELECTRICAL DIAGRAM
ELECTRICAL DIAGRAM