Owner`s manual

include floor protection for Built
-
in raised hearths. Check local codes for
approved alternatives.
Clearances are measured from the sides, back, or face (door opening).
For ceiling clearance refer to figure 4.
Clearances may only be reduced by means approved by the regulatory
Clearances may only be reduced by means approved by the regulatory Clearances may only be reduced by means approved by the regulatory
Clearances may only be reduced by means approved by the regulatory
authority.
authority.authority.
authority.
CAUTION: DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE
CAUTION: DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE CAUTION: DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE
CAUTION: DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE
INSTALLATION OF THIS UNIT.
INSTALLATION OF THIS UNIT.INSTALLATION OF THIS UNIT.
INSTALLATION OF THIS UNIT.
CAUTION: INSTALL VENT WITH
CAUTION: INSTALL VENT WITHCAUTION: INSTALL VENT WITH
CAUTION: INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT
CLEARANCES SPECIFIED BY THE VENT CLEARANCES SPECIFIED BY THE VENT
CLEARANCES SPECIFIED BY THE VENT
MANUFACTURER
MANUFACTURERMANUFACTURER
MANUFACTURER.
This heating unit must serve as a supplementary heat source. An
alternative heat source should be available in the home if needed. The
manufacturer cannot be responsible for additional heating costs
associated with the use of an alternative heat source.
It is highly recommended that the user buys this product from a retailer
who can provide installation and maintenance advices.
1.4.
1.4.1.4.
1.4. COMBUSTION AIR SUPPLY
COMBUSTION AIR SUPPLYCOMBUSTION AIR SUPPLY
COMBUSTION AIR SUPPLY
THE STOVE MUST BE CONNECTED TO AN OUTSIDE SOURCE OF
THE STOVE MUST BE CONNECTED TO AN OUTSIDE SOURCE OF THE STOVE MUST BE CONNECTED TO AN OUTSIDE SOURCE OF
THE STOVE MUST BE CONNECTED TO AN OUTSIDE SOURCE OF
COMBUSTION AIR
COMBUSTION AIRCOMBUSTION AIR
COMBUSTION AIR.
. .
.
A 4” inside diameter metallic pipe, either flexible or rigid,
must be attached to the inlet at the stove’s rear (refer to
figure 5). A rodent guard (minimum ¼” wire mesh) must be
used at the terminus (refer to figure 7). All connections
must be secured and airtight by either using the
appropriately sized hose clamp and/or UL-181-AP foil tape.
Also make sure that the fresh air damper is open while the
stove is running. The fresh air intake damper is located at
the back of the stove right hand side (refer to figure 6.).
For mobile home installations only:
For mobile home installations only: For mobile home installations only:
For mobile home installations only:
• No combustion air supply may exceed 10 feet.
Sources of Outside Combustion Air:
Sources of Outside Combustion Air:Sources of Outside Combustion Air:
Sources of Outside Combustion Air:
• A hole in floor near stove rear terminating only in a
ventilated crawl space.
• A hole in the wall behind the stove.
FIGURE 5
Rear view
FIGURE 4
Ceiling clearance