Use Instructions

DRAFT 2/12/2019 SPW 20
Locking the System
The System lock switch is located beneath the Accessory door.
The System lock may be controlled by sliding the switch to the desired position (ON or OFF).
When the System is locked, the device will prevent others from using it by disabling
treatment functionality.
Activating the System lock switch places the device in Airplane Mode. Place the System in
Airplane Mode whenever you are in a location where use of cellular devices is discouraged or
forbidden.
Adjusting the Audible Tone
The System sounds an audible tone when the device is ready to deliver a treatment.
The switch to control the audible tone is located beneath the Accessory door.
Slide the switch to the desired position (ON or OFF).
Travel
Your sTMS mini may travel with you. Place the device in Airplane Mode and pack it securely to avoid damage during
travel. Before using the unit after traveling, check it for any damage to ensure it appears to be working correctly
before you use it.
For international travel, use either the correct international plug adapter or contact eNeura to purchase the correct
plug for your battery charger. Only use the AC adapter that was provided with the System.
Caring For Your sTMS mini
Inspect your device regularly
Before using your sTMS mini always check to make sure your device is in good working order. If you notice damage to
the exterior of the device or rattling when you shake the device DO NOT USE the device and contact your eNeura
representative for a replacement.
Rechargeable Battery
The rechargeable battery in the sTMS mini is in a sealed compartment and may only be replaced by a trained service
technician. If the battery fails to recharge, please contact Customer Care to arrange for a device exchange.
Cleaning Procedure
eNeura recommends cleaning the sTMS mini every three months, similar to the way you would clean a telephone
handset. It may be necessary to clean the System more often if it becomes dirty or sticky. It may be cleaned as many
times as needed.
Only the external surfaces of the System may be cleaned. Wipe dust and lint away with a dry cloth. Take care not to
drip or spray liquid directly onto your device or get liquid into any of the ports, the buttons or the display. Dampen a
soft cloth in water premixed with a mild detergent or an alcohol- based, hospital-grade, hand-disinfecting solution.
Wring out any excess liquid, and then wipe the device. Immediately dry the device with a soft dry cloth to make sure
that no liquid remains on the surface.
Do not use any spray cleaners because fluid should not enter openings. Do not use detergents or other cleaning
solutions to clean the display.