User manual

SP ENGBO MAXI 31 32 33 34 40 43 44 Rev3.2July_2014

Maintenance and service

Replacing the line wheels 43/44-series

If the line guide spring (see the drawing on this page, pos. 27) is

too slack, or if there is not sufcient space for the rope below the

windlass, the rope can, in time, slip on the line wheel, resulting

the line wheel becoming worn. If you need to replace sheaves

(pos. 4 and 13), follow the procedure described below:

• Loosen and remove the screws and washers (16 and 15).

• Remove the outer sheav and cover (13 and 14).

• Loosen and remove the screws (7) and the rope guard/rope

guide set(6and 9)

Note! If necessary, remove the auto stop switch (5) by loosening

the nuts (11) and pull the switch out to access the screws.

• Remove and replace the inner line wheel.

• Reverse the process to assemble and t the new outer sheav.

Note! Put contact adhesive (e.g. Locktite) on the screw (16) before

tightening it.

Note! Recommened torque for bolts, 20Nm