User's Manual

15
1. Ensure that the computer in use has an Ethernet
Controller port (RJ-45 Ethernet Port). For more
information,verifywithyourcomputer’susermanual.
2. Connect one end of the Category 5e Ethernet cable into
theRJ-45portoftheEAP1200Handtheotherendto
theRJ-45portofthecomputer.Ensurethatthecable
is securely connected to both the EAP1200H and the
computer.
3. Connect the Power Adapter DC connector to the DC-IN
port of the EAP1200H and the Power Adapter to an
available electrical outlet. Once both connections are
secure,verifythefollowing:
a) Ensure that the POWER light is on (it will be orange).
b) Ensure that the 2.4 GHz/5 GHz WLAN light is on (it will
be bluefor2.4G,andgreen for 5G).
c) Ensure that the LAN (Computer/ EAP1200H
Connection) light is on (it will be blue).
  d)Once all three lights are on, proceed to set up the
Access Point using the computer.
Thisdiagramdepictsthehardwareconguration.
Hardware Installation