User's Manual

Controller Settings
With EnGenius EWS switch or EzMaster management, user can add the Access Point to the management list by itself check code.
Controller Address: Input the IP address of EnGenius EWS switch or EzMaster, then click “Test”.
Connection Status: After click “Test”, it will display the connection between Access Point and EnGenius EWS switch
or EzMaster.
SNMP Settings
This page allows you to assign the Contact Details, Location, Community Name, and Trap Settings for Simple Network Management
Protocol (SNMP). This is a networking management protocol used to monitor network attached devices. SNMP allows messages (called
protocol data units) to be sent to various parts of the network. Upon receiving these messages, SNMP compatible devices (called agents)
returns the data stored in their Management Information Bases.