User's Manual

28
Operation Modes
TheEAP1750Hsupportsthreeoperationmodes:
Access Point, WDS AP, and WDS Bridge.
Device Settings
To access operation mode, click the Wireless section under
Network in the sidebar. You will see wireless settings
customizable options for both the 2.4 GHz and 5 GHz
modes.UnderWirelesssettings,youwillsee:
Device Name: Enter a name for the device. The name you
type will appear in SNMP management. This name is not
the SSID and is not broadcast to other devices.
Region: Select a Region to conform to local regulations.
Operation Mode: Unfold the dropped list to select an
operating mode.
Band Steering:
EnableBandSteeringtosends802.11n
clients to the 5 GHz band, where 802.11b/g clients
cannotgo,andleavesthe802.11b/gclientsin2.4GHzto
operate at their slower rates. Band Steering works within
the Access Point by directing 5 GHz-capable clients to
that band.
 *Note:InorderfortheBandSteeringfunctiontowork
properly, both the 2.4 Ghz and the 5 GHz SSID and security
settings must be under the same selection settings.
Basic
This page allows you to modify the device’s IP settings.