Network Router User Manual

ECB-1220R 11b/g Wireless Client Bridge/AP/Router/Repeater Version 1.1
62
 Band: Select the IEEE 802.11 mode from the drop-down list. Options available are
2.4GHz (B), 2.4GHz (G), or 2.4GHz (B+G). Select the appropriate mode based on
the type of wireless network. For example, if you are sure that the wireless network
will be using only IEEE 802.11g clients, then it is recommended to select 2.4GHz (G)
instead of 2.4GHz (B+G) which will reduce the performance of the wireless network.
 SSID: The SSID is a unique named shared amongst all the points of the wireless
network. The SSID must be identical on all points of the wireless network and cannot
exceed 32 characters.
 Channel: Select a channel from the drop-down list. The channels available are
based on the country’s regulation. When selecting Infrastructure mode, a channel is
not required, however, when selecting Adhoc mode, you must select the same
channel on all points.
 Show Active Clients: Click on this button to view a list of associated clients.
 Click on the Apply Changes button to confirm the changes. This device will
automatically restart once these changes have been applied.
 Enable Universal Repeater Mode: Select Enable to activate Universal Repeater
Mode and type below SSID for extended wireless interface.
Advanced Settings
 Click on the Advanced Settings link under the Wireless menu. On this page you
can configure the advanced settings to tweak the performance of your wireless
network. Options available are: fragmentation threshold, RTS threshold, beacon
interval, output power, preamble type, broadcast SSID, IAPP, and 802.11g protection.