User's Manual

Chapter2 | Installation

Connecting via Wi-Fi Setup

It is recommended that to make initial setup with RJ-45 Ethernet cable and then switch to wireless after you have completed

all the settings. However, you can also start wirelessly with WPS mechanism.

Note: Ensure the gateway/router supports WPS feature and conrm that the feature is enabled.

Make sure two devices are close enough and the gateway/router is not occupied by heavy trafc or P2P loading.

I. Press the WPS button (shown below) on your gateway or router until WPS LED blinks.

II. Press and hold the WPS button on the back of your camera for 1-5 seconds and the Wi-Fi LED will start blinking

frequently. When the connectivity is complete, the Wi-Fi LED will become solid green. The process may take up to 1 minute.

Please note that there may be differences in WPS between brands; therefore, if the gateway or router does not respond to camera

connection request properly, please use RJ-45 cable for initial setup and manually congure wireless setting afterwards. Please refer

to Chapter 3 for manual wireless setup.

WPS

1~5 SECs

60 SECs

I. II.