User's Manual
75
Chapter5 | User Interface
Wireless>> WPS
Wi-Fi Protected Setup (WPS) is a network security standard that allow users to easily secure a wireless home network. This
feature allows user to set up wireless connection between the camera and home gateway/router without entering any detail wireless
security congurations such as SSID, encryption method or pre-shared key (password). However, you need to initiate WPS process on
both the camera and the gateway/router at the same time so that they can nd each other.
Normally, for WPS-enabled products, you should be able to nd the WPS button on the product. Only few rare cases that require
user to initiate WPS process over web page. Make sure WPS feature is Enabled on both the camera and your gateway/router. Then,
you need to know how to initiate gateway’s/router’s WPS process rst. It is mostly likely a simple push of the WSP button on your
gateway/router. On EDS1330, you can initiate WPS process by pressing the WPS button or through the web page.
WPS Button
The simplest way to setup wireless connection with a gateway/router is by pressing on the WPS button.
First, press the WPS button on the gateway/router (there may be changes on the LED lights as signs of initiation).
Then, press the WPS button the camera.
Wait a minute for two devices to establish the wireless connection. Once the process is complete, the WPS LED indicator will become
solid green.
WPS
1~5 SECs
60 SECs