User's Manual

5.6.2. WPS
Wi-Fi Protected Setup (WPS) is a network security standard that allows users to easily secure a wireless network. This feature allows user
to setup wireless connection between the camera and AP without entering any detail wireless security configurations such as SSID, encryption
method or pre-shared key (password). However, you need to initiate WPS process on both the camera and the AP at the same time so that
they can find each other.
Normally, for WPS-enabled products, you should be able to find the WPS button on the product. Only few rare cases that require user to
initiate WPS process over web page. Make sure WPS feature is Enabled on both the camera and your AP or wireless router. Then, you need to
know how to initiate AP or wireless router’s WPS process first. It is mostly likely a simple push of the WSP button on your AP or wireless router.
On EDS6115, you can initiate WPS process on the web page or by pressing the WPS button.
WPS Button
The simplest way to setup wireless connection with an AP or wireless router is by pressing on the WPS button.
First, press the WPS button on the AP (there may be changes on the LED lights as signs of initiation).
Then, press the WPS button of the camera.
Wait a minute for two devices to establish the wireless connection.
Done!
WPS over web page
You can initiate camera’s WPS process on the web page.