User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH210EXT.
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
1.6 Understanding the ENH210EXT LEDs
The rear of the ENH210EXT has two groups of LEDs. One group, labeled INDICATORS, shows
the status of the device. The second group, LINK QUALITY, shows the strength of the link
between the ENH210EXT and the network. The following table describes the ENH210EXT
LEDs.
LED Color Mode Status
Power
Green
OFF= ENH210EXT is not receiving power.
ON= ENH210EXT is receiving power.
LAN1
LAN2
Green(Main)
Orange(Secondary)
OFF = ENH210EXT is not connected to the network.
ON = ENH210EXT is connected to the network, but not sending
or receiving data.
Blink = ENH210EXT is sending or receiving data.
WLAN
Green
Access Point
or Client
Bridge Mode
OFF = ENH210EXT radio is off and the device is
not sending or receiving data over the wireless
LAN.
ON = ENH210EXT radio is on, and the device is
not sending or receiving data over the wireless
LAN.
Blink = ENH210EXT radio is on, and the device is
sending or receiving data over the wireless LAN.
Link Quality
See Status column
Access Point
or Client
Bridge Mode
Shows the strength of the link between the
ENH210EXT and the network.
G = good quality (green).
Y = medium quality (yellow).
R = poor or no link (red).