User's Manual

2 Installation
This chapter describes how to install the ENH210EXT.
Only experienced installation professionals who are familiar with local building and
safety codes and, wherever applicable, are licensed by the appropriate government regulatory
authorities should install the ENH210EXT.
2.1 Pre-installation Guidelines
Select the optimal locations for the equipment using the following guidelines:
- The ENH210EXT should be mounted on a 1"- 4" pole or wall. Its location should enable
easy access to the unit and its connectors for installation and testing.
- The higher the placement of the antenna, the better the achievable link quality.
- The antenna should be installed to provide a direct or near line of sight link with the base
station antenna. The antenna should be aligned to face the general direction of the base
station.
2.2 Installing the ENH210EXT
To install the ENH210EXT, use the following procedure to mount the device on a pole and
refer to the figure below.
1. Insert a standard Ethernet cable into the RJ-45 port labeled LAN1(PoE).
2. Remove the power cord and PoE injector from the box and plug the power cord
into the DC port of the PoE injector.
Only use the power adapter supplied with the ENH210EXT. Using a different
power adapter might damage the ENH210EXT.
3. Plug the other side of the Ethernet cable in Step 1 into the PoE port of the PoE
injector. When you finish Step 3, the installation will resemble the following picture.