User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH210EXT.
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
Wireless Mode The wireless mode supports 802.11b/g/n mixed operation. It is
compatible with the most common wireless bands.
Channel HT Mode The default channel bandwidth is 40 MHz. A larger channel can
provide better transmit quality and speed.
Extension Channel Specify the upper channel or lower channel selection. It may
influence the Auto channel function.
Channel / Frequency The channel availability is determined by the country’s
regulations. The device operates in the 2.4GHz spectrum.
Auto Place a check mark to enable Auto channel selection.
AP Detection AP Detection can help to select a best channel by scanning the
nearby area.
Current Profile Configure up to four different SSIDs; it allows for the division of
clients into separate groups to access the network. Press Edit to
configure the profile and place a check to enable an additional
SSID.
Profile Isolation Restrict client communications with different VID by selecting the
Radio button.
Accept / Cancel Press Accept to confirm the changes or Cancel to return to the
previous settings.
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 4.1 for more information.