User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH210EXT.
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
MAC Address Enter the Access Point’s MAC address that you would like to
extend the wireless coverage of into the MAC address filter.
Mode Select Disable or Enable from the drop down list.
Accept / Cancel Press Accept to confirm the changes or Cancel to return
previous settings.
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 4.1 for more information.
The MAC address of the AP that you would like to extend the wireless coverage
of must be entered. Not all Access Points supports this feature.
8 LAN Setup
This section will guide you to setup the Local Area Network (LAN) settings