User's Manual
Table Of Contents
- Conventions
- Table of Contents
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix
PRODUCT OVERVIEW PRODUCT LAYOUT
1-5
1.3 Product Layout
Figure 1-1: Back Panel View
BACK PANEL VIEW DESCRIPTION
A Power LED
OFF = ENH500 is not receiving power
ON = ENH500 is receiving power
B LAN (2) LEDs
OFF = ENH500 is not connected to the
network.
ON = ENH500 is connected to the network,
but not sending or receiving data
Blink = ENH500 is sending or receiving data
CWLAN LED
(Access Point or Client Bridge Mode)
OFF = ENH500 radio is off and the device is
not sending or receiving data over the
wireless LAN.
ON = ENH500 radio is on, and the device is
not sending or receiving data over the
wireless LAN.
Blinking = ENH500 radio is on, and the
device is sending or receiving data over the
wireless LAN.
D Signal Indicator LED
(Client Bridge, WDS Station and Client
Router Mode)
Green - Signal is good
Orange - Signal is normal
Red - Signal is weak or non-existent