User Manual

2.4 Hardware Installation

1. Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port). For more information, verify User Manual.

2. Connect one end of the Category 5e Ethernet cable into RJ-45 port of the ERA150 and the other end to the RJ-45 port

on the computer that will use the ERA150. Ensure that the cable is securely connected to both the ERA150 and the

Computer.

3. Connect the Power DC inlet to the DC-IN port of the ERA150 and the Power adapter to the electrical outlet.

Once both connections are secure, verify the following:

a) Ensure that the POWER light is on (it will be green).

b) Ensure that the WLAN light is on (it will be green).

c) Ensure that the LAN (Computer/ERA150 Connection) light is on (LAN1 will be green and LAN2 will be orange).

d) Once all three lights are on, proceed to setting up the computer.

This diagram depicts the hardware configuration.

Note: ERA150 supports both IEEE 802.3af PoE (Power over Ethernet) and regular power adapter. You should use either one as the power source.

Please do not apply both at the same time.