User Manual

BASIC NETWORK SETTINGS CLIENT ROUTER MODE
4-28
Client Router Mode
In Client Router Mode, you can access the Internet wirelessly with the support of a WISP. In AP Router Mode, the ENS200 can
access the Internet via a cable or DSL modem. In this mode, the ENS200 can be configured to turn off the wireless network name
(SSID) broadcast, so that only stations that have the SSID can be connected. The ENS200 also provides wireless LAN 64/128/156-
bit WEP encryption security, WPA/WPA2, and WPA-PSK/WPA2-PSK authentication, as well as TKIP/AES encryption security. It also
supports VPN pass-through for sensitive data secure transmission.
Wireless Mode Wireless mode supports 802.11b/g/n mixed
modes.
SSID Specify the SSID if known. This field is completed
automatically if you select an Access Point in the Site Survey.
Site Survey Scans nearby locations for Access Points. You can
select a discovered Access Point to establish a connection.
Prefer BSSID Enter the MAC address if known. If you select an
Access Point in the Site Survey, this field is completed
automatically.
Wireless Security See Configuring Wireless Security.
Click Accept to confirm the changes or Cancel to cancel and return previous settings.
Profile If you used the Site Survey, the Web Configurator
shows nearby Access Points. To connect to an Access Point,
click the Access Point’s BSSID.
Wireless Security See Configuring Wireless Security.
Click Refresh to scan again.