User Manual

BASIC NETWORK SETTINGS CONFIGURING WIRELESS MAC FILTER
4-39
4.4.3 Configuring Wireless MAC Filter
Wireless MAC Filters are used to allow or deny network access to wireless clients according to their MAC addresses. You can manu-
ally add a MAC address to restrict the permission to access ENS200. The default setting is Disable Wireless MAC Filters.
Note:
This section applies to Access Point and WDS Access point mode.
ACL Mode Determines whether network access is granted or
denied to clients whose MAC addresses appear in the MAC
Address table on this page. Choices are Disable, Deny MAC in
the list, or Allow MAC in the list.
MAC Address Filter Enter the MAC address of the device.
Click Add to add the MAC address to the MAC Address table.
Click Apply to apply the changes.