User Manual

BASIC NETWORK SETTINGS ROUTER SETUP
4-12
4.3 Router Setup
4.3.1 Configuring WAN Settings
Configure the WAN settings for the ENS200 using a static or dynamic IP address, PPPoE or PPTP.
Static IP
Setting a static IP address allows an administrator to set a specific IP address for the router and guarantees that it can not be
assigned a different address.
Account Name Enter the account name provided by your ISP
Domain Name Enter the domain name provided by your ISP
MTU The maximum transmission unit (MTU) specifies the
largest packet size permitted for an internet transmission. The
factory default MTU size for static IP is 1500. The MTU size
can be set between 512 and 1500.
IP Address Enter the router’s WAN IP address.
Subnet Mask Enter the router’s WAN subnet mask.
Default Gateway Enter the WAN gateway address.
Primary DNS Enter the primary DNS server address.
Secondary DNS Enter the secondary DNS server address.
Discard Ping on WAN Check to Enable to recognize pings on
the ENS200 WAN interface or Disable to block pings on the