User's Manual Part 1

1. Remove the rear bottom panel.

2. Connect one end of the Ethernet cable into the main

LANport(PoE)oftheAccessPointandtheotherendto

the AP Ethernet port on the PoE Adapter.

3. Connect the Power cord to the PoE Adapter and plug

the other end in to an electrical outlet.

4. Connect the second Ethernet cable into the LAN port of

the PoE Adapter and the other end to the Ethernet port

on the computer.

5. Place the panel back into device

Note: The EnStationAC should ONLY be powered via

Ethernet cable connected to included supports both IEEE

802.3atPoE(PoweroverEthernet)ortheincludedPoE

Adapter.Youmayuseeitheroneasthepowersource.

Do NOT use both at the same time.

Note: TheEnStationACcansupplythe802.3afpower

source when used with included PoE Adapter.

.Thisdiagramdepictsthehardwareconguration.

To attach the EnStationAC to a pole using the

provided pole mounting kit:

Hardware Installation

Ethernet

Power

Outlet

PoE Adapter