Network Router User Manual

ESR-9710 Wireless N Gigabit Router Version 1.0
7
1.4 Wireless SOHO Router Description
WAN
WAN
LAN: 4*RJ45
LAN: 4*RJ45
10/100/1000M
10/100/1000M
DC JACK
DC JACK
SMA
SMA
SMA
SMA
SMA
SMA
WAN
WAN
LAN: 4*RJ45
LAN: 4*RJ45
10/100/1000M
10/100/1000M
DC JACK
DC JACK
SMA
SMA
SMA
SMA
SMA
SMA
Step Label Description
1 LAN Ports (1 – 4) Use an Ethernet cable to connect each port to a computer
on your Local Area Network (LAN).
2 WAN Port Use an Ethernet cable to connect this port to your WAN
router.
3 DC Connector Use the power cable and connect the adapter to the power
socket on the wall, and the DC inlet into the DC connector.
4 Antenna Connector Connect the three antennas to the SMA connectors.
Connection / Activity
LED
This LED will light up once an Ethernet cable is connected
to one of the LAN ports.
WAN LED This LED will light up once an Ethernet cable is connected
to WAN (Internet) port.
WLAN LED This LED will light up once the RF (wireless LAN) feature is
enabled
Power LED This LED will light up once the power cable is connected to
the DC connector.
Reset Button Use this button to reset the device. You can restore the
device back to its factory default settings by holding down
on this button for 5 seconds.
WPS WPS (Wireless Push Button) is used for WiFi Protected
Setup. By pressing this button, the security settings of the
LAN Ports (1-4)
WAN Port DC Connector
LAN 1- 4 LED
Power LED
Rea
r
Panel
Front Panel
WLAN LED
WAN LED
A
ntenna
Connector
Antenna
Connector
A
ntenna
Connector
Reset Button WPS Button