User's Manual

80
Controller Settings
Adding EWS1025CAM to ezMaster Device Inventory, you must first bind the AP to ezMaster's Device Inventory by ‘registering’ the device.
You can manually redirecting each AP to ezMaster, or skip this section if you are managing only local devices. You can test the ezMaster
Device Inventory by IP address, and get the connection status between EWS1025CAM and ezMaster Device Inventory.
SNMP Settings
This page allows you to assign the Contact Details, Location, Community Name, and Trap Settings for Simple Network Management
Protocol (SNMP). This is a networking management protocol used to monitor network attached devices. SNMP allows messages (called
protocol data units) to be sent to various parts of the network. Upon receiving these messages, SNMP compatible devices (called agents)
returns the data stored in their Management Information Bases. To configure SNMP Settings, click under the
Advanced
tab on the side
bar under
Management
.