SN-920 Cell Phone User's Manual

~40~
4. Press the LEFT SOFT FUNCTION
key for "."
5. Deregistration is successful.
YES
The handset has now been de-registered
from all base units. The handset ID number
will be reset to "00" as seen in the middle
of the top LCD line.
Dereg from
all bases
Register a Second, Third or Fourth Base Unit
A handset can be registered to a maximum of 4
base units. All base units that come from the factory are
registered as base unit 01.
NOTE:
If there is more than one base unit and a handset
is to be registered to more than one base unit, the base
unit's identification number must be changed from factory
default number of "1" to either "2", "3", or "4".
NOTE:
1. Plug in the new base unit to AC power and place a fully
charged battery pack into the handset.
2. Verify base unit's power light is on and turn on the handset
power by pressing and holding the END key for 2 seconds.
~39~
Upon successful registration, your handset will
display "Reg OK New ID = "
Your handset will automatically exit the
REGISTRATION mode after 30 seconds.
You can register your handset to a maximum of 4
base units. The handset ID number in the middle
of the top line of the handset display will not
change after registering the first base unit
(known as the primary base unit).
NOTE 1:
NOTE 2:
NOTE 3:
SECURITY FUNCTION:
MENU63
A third option is available for
deregistering all the handsets at once and generating a
new base ID code (system registration reset). This option
can be selected by pressing "", "", "", then enter
a new base number (1-4). Both the handset and base
must be in the registration mode.
De-Registering a Handset from all Base Units
1. Press the RIGHT SOFT FUNCTION key to select .
2. Press the "" key to select the REGISTER option.
3. Press the "" key to select
RESET HAND. The LCD will
display the following screen:
MENU
6
4
Dereg from
all bases?
YES NO
* Handset registered to a base with same ID.
9. Press END to return to the handset main menu.
ID Conflict
Base X