User's Manual

13
Basic Base Station Features
1.
Antenna
a. The antenna port has a reverse thread connector; to remove
antenna or cable, turn clockwise; to install, turn
counterclockwise. Improper installation may damage the
conn
ector
.
b. When using an outdoor antenna, locate the antenna (not the
base station itself) as high as possible for a clear transmission
path.
2.
Audio
-
in Jack
(3.5mm)
3.
Line Status LED
Indicates an active telephone line.
4.
Power
LED
Indicates base station has power.
5.
L1
–
L4
Standard RJ
-
11C/CA
-
11A connector t
o plug in the telephone line
6
.
DC In
Jack
(f
or AC power adapt
e
r
)
Re：The AC power adapter is 100~240VAC/12VDC, do not use other
non
-
compatible AC, in case any damage or safety issue.
7
.
Registration
Key
(REG)
Enters registration mode along with handset, assigns handset ID (10
-
90).
8
.
Reset Button
a.
Restores base station to factory settings
b.
Reset button is indented to p
revent accidental system reset.
c. All handsets (including administrator) and additional base(s)
need to be re
-
registered after a base station reset.
9.
Grounding jack
Connecting with grounding
wire
10.
Console jack
Jack for firmware upgrad
e (Type
-
B USB connector)
14
Re: Please consult with EnGenius Tech support about the firmware
upgrade.