User's Manual
~
27
~
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination handsets will be opened up
d.
Release
“
PTT
”
key
to end the broadcast
ing
3.
Broadcasting an individual handset
a.
Enter the Handset ID
and then press
"PTT”
key
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted once
you hear the “beep” sound; the speakerphone of
destination handsets will be opened up
d.
Release
“
PTT
”
key
to end the broadcast
ing
Making a Broadcast via UHF
A. Handset to UHF walkie-talkie
1.
Activate walkie
-
talkie mode
a. Enter the key sequence MENU - 5 - # - 1, then select
“ON” to enable the WT mode in analog UHF band.
After press “End” to back idle mode. You can see
the display with a walkie icon.
2.
Broadcasting all
UHF walkie
-
talkie
handsets
a.
Ensure
the
same setting for channel/
Frequency/Code before doing the broadcast
b. Press “PTT” key, the display will show channel and
transmitting a broadcast to all handsets within
communication coverage
c. Start to speak the message to be broadcasted
immediately; the speakerphone of destination
handsets will be opened up
d.
Release
“
PTT
”
key
to end the broadcast
ing
Scanning via UHF
The Scan feature is to check continuously for activity on the channels. You should
activate which channels desired to scan in UHF mode setting. You can scan up to 5
channels as settings. When the radio detects activity, it stops scanning and locks it
on the active channel.
11
PA paging
to Ext. # 12
1
0
PA paging
to Ext. # 12
1
0
1
DuraFon PRO
REDIAL MENU
~
28
~
1. Press “MODE” key 6 times to enter the scan channel
setting. You can use “Up” or “Down” key to select which
channel to be scanned
2.
Press “Left” soft key to enable/disable this channel
scanning
3. Press “MODE” or “END” key to exist the setting. After
10 seconds, the radio begins to scan the channel. You
can see the scan icon and rolling channel number.
When the radio detects activity, it stops scanning till
without signal.
4. If you want to stop scanning, you need to enter the
setting as above step 1,2 to disable all the activated
scanning channel.
Redial
1.
Press
REDIAL
(Left) soft key.
2.
The LCD shows the last phone number diale
d. To dial this number, press
DIAL
(Left) soft key.
3.
Use or Arrow Key to scroll through the last 10 phone numbers
dialed. Select and press DIAL soft key.
[Note]
Intercom numbers (Handset ID
) are not stored in the last 10
numbers
dialed log.
Receiving a Telephone Call
1. When an incoming call arrives, the ringer will ring or vibrate unless the ringer
has been turned off.
2.
If the handset is on the charger cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and start conversation.
1
0
4
Scan Channel
Off
1
1
0
Du
raFon PRO
REDIAL
MEN
U
Z
4
1
0
4
Scan Channel
On
1