User's Manual

~
29
~
3.
If the handset is not on the cradle, press any key (except , and the Silent
soft key) to answer.
4.
During the call, press the key, the speakerphone is active.
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset
menu), the SILENT key operation is valid only for the current
call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked
by the caller or the originating phone company.
Receiving an Intercom Call
1.
When an intercom call arrives, the ringer will r
ing or vibrate unless the ringer
has been turned off. Press to answer the intercom call.
2.
If the handset is on the charger cradle (ringer will be temporarily switched to
“Ring” if it has been set to “Vibrate”), lift the handset and start conversation.
3.
If the handset is not on the cradle, press any key (except , and the SILENT
soft key) to answer.
4.
During the call, press the key, the speakerphone is active.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer the SILENT key operation is
valid only for the current call.
Ending a Call
To end a telephone or intercom call, press key or place handset into charger
cradle.
~
30
~
Adjusting Receiver (Earpiece) Voice Volume
1.
Voice volume can only be adjusted during a call.
2.
There are 6 levels of volume selections. Default =
3
.
Use
or arrow key to adjust
3. The new setting remains effective for all future calls
until changed.
Adjusting Speaker Volume
Placing a Call On Hold
1.
When a call is in progress, it can be put on hold by
pressing the HOLD (Right) soft key.
2.
To return to the conversation, press
U
NHOLD
Notes:
1. The call being placed on hold can only be “un-hold” by the
handset that puts it on hold.
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.
4. You can power off the handset (e.g., change battery) while call
is on hold. After power on again, you can continue the call by
pressing UNHOLD (Left) soft key to terminate the hold state.
1. The volume from speaker can only be adjusted by On-
Off/Volume knob.
2.
Rotate knob clockwise to increase
and
counterclockwise
to decrease volume


1
0
00:00:10
Volume:4
MUTE HOLD


1
0

1
You have a
Call on hold
UNHOLD
OPTION


1
0

1
DuraFon PRO
UNHOLD OPTION