User's Manual

This page displays the current status of the Wireless

settings ofthe AP/CPE.

Wireless Network

EnStation5-ACv2/EnStationACv2/ENS500-ACv2/

ENS500EXT-ACv2 Wireless: The AP/CPE supports

802.11ac/n mixed modein 5 GHz.

Operation Mode: Select Operation Mode. When EnJet

enable, The AP/CPE can be seted as Access Point, Client

Bridge or WDS(AP& Station) or AccessPoint, ClientBridge

or WDS(AP, Station & Bridge)when EnJet disable.

Channel HT Mode: The default channel bandwidth is 20

MHz/ 40 /80 MHz. The larger the channel, the greater the

transmission quality andspeed.

Channel: Click Configuration button to open a new

windows to configure channels for performing wireless

service.

Transmit Power: Sets the power output of the wireless

signal.

Bit Rate: 5GHz is default 6 Mbps, the range can control

by BAR via scroll from 6Mbps to 54Mbps.

Client Limits: When EnJet enable, limits the total number

of clients. Once setting the ceiling of client numbers, the

maximum assocaited client devices will be restricted at

this number.

AP Detection: AP Detection can select the best channel to