User's Manual

SNMP Settings
This pageallows youto assign the Contact Details, Location,
Community Name, and Trap Settings for a Simple Network
Management Protocol (SNMP). SNMP is a networking
management protocol used to monitor network attached
devices. SNMP allows messages (called protocol data units)
to be sent to various parts of the network. Upon receiving
these messages, SNMP compatible devices (called agents)
returns the data stored in their Management Information
Bases.
SNMP Enable/Disable: Enables or disables the SNMP
feature.
Contact: Specifies the contact details of the device.
Location: Specifies the location of the device.
CommunityName (Read Only): Specifies the password
for the SNMP community for read only access.
Community Name (Read/Write): Specifies the password
for the SNMP community with read/writeaccess.
Trap Destination Address: Specifies the IP address of the
computer that will receive the SNMP traps.
Trap Destination Community Name:Specifies the
passwordfor the SNMP trap community.
SNMPv3: Enables or disables the SNMPv3 feature.
User Name:Specifies the username for SNMPv3.
Auth Protocol: Selects the authentication protocol type:
MDS or SHA.
Auth Key: Specifies the authentication key.
Priv Protocol: Selects the privacy protocol type:DES.
Priv Key: Specifies the privacy key for privacy.
Engine ID: Specifies the engine ID for SNMPv3.
Apply Save:ClickApply Save to apply the changes.
Advanced Settings
52