User manual

91
9.8. Routing
If your WIRELESS ROUTER device is connected a network
with different subnets, then this feature will allow the
different subnets to communicate with each other.
Note: NAT function needs to be disabled for the Routing feature to
be enabled.
Static Routing
Enable Static Routing: Tick this box to Enable the Static Router feature.
Destination LAN IP: Enter the IP address of the destination LAN.
Subnet Mask: Enter the Subnet Mask of the destination LAN IP address
Default Gateway: Enter the IP address of the Default Gateway for this destination IP and Subnet.
Hops: Specify the maximum number of Hops in the static routing rule.
Interface: Select whether the routing applies to LAN or WAN interfaces.