Operation Manual

49 / 60
Creating a basic captive portal using ezMaster authentication
The steps below will guide you to create a basic captive portal using ezMaster authentication.
1. Select a project and navigate to Hotspot Service > Captive Portal.
2. Click on Add.
3. Fill in the Profile Name and Description.
4. For Authentication Type, select ezMaster Authentication.
5. For Splash Page, select Local Splash Page and customize your splash page by uploading a logo,
entering a custom message, and terms or use if desired.
6. Scroll to the bottom of the page and click on Save Changes.
7. Next, navigate to Hotspot Service > Guest Account.
8. Click on Add.
9. Create a new entry by filling in the user name, password and description.
10. Click on Apply to continue.
11. Navigate to Device Management > Device Config > Access Point.
12. Click on the device name (or group name) of the AP (or group) you wish to apply captive portal settings
to.
13. Under Guest Network, choose Enable and select the captive profile you just created (make sure your
2.4GHz/5GHz Guest Network SSID is enabled).
14. Scroll to the bottom of the page and click on Apply.
Once the above procedure is completed, a wireless client will be re-directed to the splash page every time
it associates to your Guest Network.