User manual

EnGenius Mesh AP - M8000 User Manual & Configuration Guide
EnGenius Mesh AP - M8000 User Manual & Configuration Guide
Page 15 of 62
Figure 5.2.2: VLAN0 – edit page
VLAN0 - edit page contain the following parameter:
o ID – Enter the VLAN ID.
o Type – Click on “Type” drop down menu to select “Static” or “DHCP”.
o IP – Specify the VLAN IP address.
o Netmask – Specify the network mask for this IP.
o Routed – Click on “Routed” drop down menu to select “Routable
address” or “NAT address”. A routeable network is visible to other Mesh
Node.
o Comments – Specify VLAN comments.
o Active – Click on “Active” drop down menu to select enable or disable
VLAN.
o “Apply” button to save any changes made. New settings are active
after the device reboot.
• To edit inactive VLAN, click on “Inactive VLAN” drop down menu, select on
VLAN you want to edit. For example, select VLAN1. Click on bottom “Edit”
button to edit inactive VLAN1.
• VLAN1 – edit page will display as shown in Figure 5.3.2