User manual

EnGenius Mesh AP - M8000 User Manual & Configuration Guide
EnGenius Mesh AP - M8000 User Manual & Configuration Guide
Page 38 of 62
• Reconfirm Certificate Password – Re-enter certificate password to confirm it.
• Access Control – Enable or disable access control.
• “Apply” button to save any changes made. Please reboot to enable new
settings.
• “Modify” button to edit current selection.
• “Remove” button to edit current selection.
• “New Entry” button to add entry to the access control table.
Figure 7.1.2 illustrates the access control configuration page.
Figure 7.1.2: HTTPD Access Control – add or edit page
HTTPD Access Control page contains the following parameters:
• Device – Click on “Device” drop down menu to select device. For example
WAN, MESH, VLAN0……
• Using – Click on “Using” drop down menu to select using “Device” or
“Network”.
• Subnet – Specify subnet to access or deny access HTTPD server configuration
page.
• Netmask – Specify netmask for this subnet
• Comments – Enter comments for this entry.
• Active – Enable or disable this entry.
• “Apply” button to save any changes made. Please reboot to enable new
settings.