User manual

EnGenius Mesh AP - M8000 User Manual & Configuration Guide
EnGenius Mesh AP - M8000 User Manual & Configuration Guide
Page 43 of 62
• Active – Enable or disable SNMP management.
• Version – Select “v1 or v2c”, “v3”, or “all” SNMP version.
• Port – Enter the SNMP port number.
• v2 Read Community – Enter the v2 Read Community.
• Reconfirm v2 Read Community – Re-enter v2 Read Community to verify.
• v2 Read-write Community – Enter the v2 Read-write Community.
• Reconfirm v2 Read-write Community – Re-enter v2 Read-write Community
for verification.
• v3 Read Username – Enter the v3 Read Username.
• v3 Read-write Username – Enter the v3 Read-write Username.
• v3 Password – Enter the v3 Password.
• Reconfirm v3 Password – Re-enter v3 Password for verification.
• v3 Passphrase – Enter the v3 Passphrase.
• Reconfirm v3 Passphrase – Re-enter v3 Passphrase for verification.
• Access control – Enable or disable SNMP access control.
• “Apply” button to save any changes made. Please reboot to enable new
settings.
• “Modify” button to edit access control entry.
• “Remove” button to remove access control entry.
• “New Entry” button to add new access control rule.
Figure 7.3.2 illustrates the access control configuration page for SNMPD
Figure 7.3.2: SNMP Access Control – add or edit page