User manual

EnGenius Mesh AP - M8000 User Manual & Configuration Guide
EnGenius Mesh AP - M8000 User Manual & Configuration Guide
Page 46 of 62
7.5 Management > Trap
Trap used to report an alert or other asynchronous event about managed system.
Figure 7.5.1 illustrates the trap configuration page.
Figure 7.5.1: Trap configuration page
Trap configuration page contains the following parameters:
• Active – Enable or disable trap report.
• Configuration – Enable or disable report on configuration issue.
• Security – Enable or disable security trap report.
• Wireless – Enable or disable wireless trap report.
• Operational – Enable or disable operational trap report.
• Flash – Enable or disable flash trap report.
• Tftp – Enable or disable tftp trap report.