Clean Lead Bass Middle Treble Reverb Lead Presence Lead Volume Master Input Bright Lead Boost Clean Lead Screamer 100 Stand By Power TUBE - AMPLIFIER Screamer 100 Operator´s Manual Please, first read this manual carefully!
Screamer - a really great fully-tube guitar amplifier: The right choice for Rock and Blues! Sensible features and a very clear arrangement of the controls allow an easy handling of this amp. An exeptional noble optical design and the unique, creamy warm tube-sound combined with an excellent sounding spring reverb gives this amplifier an noninterchangeable character. Channel selection, Lead Boost, two different Master volumes (V.L.S.
Rear Panel VOLTAGE FUSED ! 100-120 V 5A CAUTION ! 220-240 V 2,5 A DO NOT OPEN ! RISK OF ELECTRIC SHOCK ! DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE ! Footswitch Poweramp Output F.X. Loop Balanced Line Output MADE IN GERMANY WIRED FOR: All-tube Guitar Combo Amplifier 230 VOLT SERIAL NUMBER: REPLACE FUSE ONLY WITH SAME TYPE AND RATING ! 17 18 Screamer 100 V.L.S.
27 Level: Signal level control for the frequency-corrected line output; it is used to match the amp’s signal level at the Line output to the mixing console or recorder’s input. 28 Overload: This LED denotes the Line output is overloading; in this case, reduce the signal’s level via the Level control. 29 Line Out Frequency Compesated: The frequency-corrected, balanced Line output jack (XLR; Pin 2 and 3 signal, Pin 1 = N.C. ). This signal can be routed directly to a mixing console or a recording unit.
Clean Lead Bass Middle Treble Reverb Lead Presence Lead Volume Master Input Bright Lead Boost Clean Lead Screamer 100 Stand By Power TUBE - AMPLIFIER Amp: V.L.S.
Handling and Care Protect the amp from mechanical knocks (tubes!). Let the amp cool down before you transport it (approx. 10 minutes). Tubes need about 20 seconds to warm up after you switch the power on, and furtheron a few minutes before they reach their full power capability. Avoid storing the amp in damp or dusty rooms, they are hard on jacks, switches and potentiometers. Make sure air can circulate at the rear side and the top of the amp to allow for adequate cooling (increases component life).