Owner's Manual

ManualsBrandsEngland's Stove Works ManualsStoveEngland's Stove Works 13-NCI

INSTALLATION & OPERATION MANUAL

MODEL NUMBERS: 13-NCI 50-SNC13I 50-TNC13I

Thank you for purchasing this product from a fine line of heating equipment.

We wish you many years of safe heating pleasure with your new heating appliance.

Save These Instructions.

NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO THE

DEALER. CONTACT TECHNICAL SUPPORT @ 1-800-245-6489.

Questions? Need Parts or Options? www.englanderstoves.com

Please Note the Following Precautionary Statements:

CAUTION: This unit must be installed in accordance with these instructions and must comply

with local building and fire codes. Failure to do so could result in a chimney or

house fire.

Keep children, furniture, fixtures, and all combustible materials away from any

heating appliance. Refer to this owner’s manual for all clearances to combustible

materials.

DO NOT INSTALL THIS UNIT IN A MOBILE HOME OR DOUBLE WIDE!!!

DO NOT INSTALL THIS UNIT IN A PRE-MANUFACTURED FIREPLACE!!!

FOR MASONRY FIREPLACE INSTALLATION ONLY!!!

SAVE THIS MANUAL FOR FUTURE REFERENCE

Read this entire manual before you install and use your new room heater. If this room

heater is not properly installed, a house fire may result. To reduce the risk of fire,

follow the installation instructions. Failure to follow instructions may result in

property damage, bodily injury, or even death.

England’s Stove Works highly recommends the use of smoke detectors and Carbon

Monoxide detectors with any hearth product, including this unit. Follow all manufacturer’s

instructions when using smoke or Carbon Monoxide detectors.

Rev. 9/2014

Summary of content (21 pages)

PAGE 1
INSTALLATION & OPERATION MANUAL MODEL NUMBERS: 13-NCI 50-SNC13I 50-TNC13I Thank you for purchasing this product from a fine line of heating equipment. We wish you many years of safe heating pleasure with your new heating appliance. Save These Instructions. NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO THE DEALER. CONTACT TECHNICAL SUPPORT @ 1-800-245-6489. Questions? Need Parts or Options? www.englanderstoves.
PAGE 2
A letter from our Technical Support department: Thank you for purchasing this fine product from England’s Stove Works! England's Stove Works was started, and is still owned by, a family that believes strongly in a "Do It Yourself" spirit – that’s one reason you found this product at your favorite “Do It Yourself” store.
PAGE 3
CAUTION We highly recommend installation of this fireplace insert by a professional installer. The “Direct Connect” method of installation must be used (see Installation section of manual). If you have any doubt concerning your ability to complete your installation in a professional-like manner after reading these instructions, you should obtain the services of an installer who is versed in all aspects as to the correct and safe installation. Do not use temporary, makeshift compromises during installation.
PAGE 4
SAFETY NOTICE: IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS FOR RESTRICTIONS AND INSPECTIONS IN YOUR AREA. SECTION I: FLUE SYSTEM This stove is designed to install into a masonry fireplace. The minimum opening is 28” wide x 24” high x 16” deep and you must have at least fourteen inches (14”) of hearth extending from the fireplace face.
PAGE 5
*IMPROPER INSTALLATION: The manufacturer will not be held responsible for damage caused by the malfunction of a stove due to improper installation. Do not use makeshift methods or material which may compromise the installation. England’s will not be liable for consequential or indirect damages to property or persons resulting from the use of this product. Call (800-245-6489) and/or consult a professional installer if you have any questions.
PAGE 6
Attempts to achieve higher output rates that exceed heater design specifications can result in permanent damage to the heater. The recommended wood load is level with the top of the firebricks. Overloading may prevent sufficient air entering the heater to properly fuel the fire. Do not tamper with the combustion air control beyond the normal adjustment capacity. Operate this heater only with the door closed. ALWAYS PROVIDE A SOURCE OF FRESH AIR INTO THE ROOM WHERE THE UNIT IS INSTALLED.
PAGE 7
SECTION V: FLOOR PROTECTION Hearth Extension The firebox on your insert will extend out eight inches (8”) from the face of the fireplace, so you will need at least sixteen inches (16”) in front of the door. If you do not have this, it will require you to place an approved floor protector in front of the stove (such as a hearth extender shield).
PAGE 8
Steel Riser * Illustration 2 BRICK LAYOUT 1 – 9” x 4” x 1.25” brick (Qty. 15*) 2 – 9” x 4” x 1.25” brick w/ .75 x .75 notch (Qty. 2) 3 – 4” x 2” x 1.25” brick (Qty. 1) *Note- Front brick where door wedge closes is actually notched – Part Number AC-SBN, 9” x 4” x 1.25” brick with 1” x 3” notch, qty.
PAGE 9
Illustration 3 BACKPLATE INFORMATION: Your backplate is a three (3) section plate that needs to be assembled before installation on your insert unit. A roll of insulation is also included, which needs to be installed around the outside perimeter of the plate (even with the “bend line”), and at the two connection joints to insure a proper seal between the plate and the hearth.
PAGE 10
SECTION VI: NOTES ON PLACEMENT The first challenge you may encounter is getting your stove into your home -- all of our stove products are well constructed, which makes them rather heavy. Three to four adults can normally handle a unit, but we still recommend using a handcart. Never attempt to handle a heating product alone!!! The door and brick can be temporarily removed to lighten the unit (refer to Brick Layout).
PAGE 11
6. This unit is designed to function most effectively when air is allowed to circulate to all areas of the firebox. A good way of achieving this is to rake a small (1” to 2” wide) “trough” in the center of the coal bed, from front to back, prior to loading the fuel. 7. Once fuel has been loaded, close the door and fully open the air inlet control, until the fire is well established (approximately 20 minutes), being careful not to over-fire. 8. Readjust the air inlet control to the desired burn rate.
PAGE 12
3. Do not clean the glass with materials which may scratch (or otherwise damage) the glass. While surface scratches are acceptable, deeper scratches on the glass can develop into cracks or breaks. 4. Never attempt to clean the glass while the unit is hot. If the deposit is not very heavy, normal glass cleaners are adequate with a plain, non-abrasive scouring pad. Heavier deposits may be removed with the use of an oven cleaner. 5.
PAGE 13
Placement of Stainless Steel Burner Tubes for all 13-NC, 50-SNC13 and 50-TNC13 (freestanding and insert) stove models.
PAGE 14
SECTION XI: FIBER BOARD: CARE & MAINTENANCE THIS WOOD HEATER UTILIZES NEW TECHNOLOGY, WHICH INCLUDES A CERAMIC FIBER BOARD THAT IS LOCATED IN THE FIREBOX, AND RESTS ON TOP OF THREE (3) STAINLESS STEEL TUBES. DO NOT REMOVE THIS CERAMIC FIBER BOARD!!! IT IS A NECESSARY COMPONENT OF THE FIREBOX. ALSO PLEASE NOTE: THE CERAMIC FIBER BOARD MAY BECOME LOOSE DURING INITIAL SHIPPING.
PAGE 15
WAYS TO PREVENT AND KEEP UNIT FREE OF CREOSOTE 1. Burn with the air control fully open for several minutes at numerous intervals throughout each day during the heating season, being careful not to over-fire the unit. This should remove the slight film of creosote that accumulates during low burn periods. 2. Burn the stove with the draft control fully open for approximately 20-30 minutes every time you apply fresh wood.
PAGE 16
   Once the kindling has begun to burn, start adding some small pieces of seasoned, dry firewood. NOTE: Adding large pieces at the early stages will only serve to smother the fire. Continue adding small pieces of seasoned, dry firewood, keeping the door slightly open until each piece starts to ignite. Remember to always open the door slowly when placing wood into the fire. Once the wood has started to ignite and the smoke has reduced, close the stove door fully.
PAGE 17
9. What can cause a poor draft? There are several common factors that can contribute to poor draft: A. Atmospheric Pressure and Air Supply Atmospheric pressure affecting the draft from a chimney can be outside the home, inside the home, or both. Outside the home, a high-pressure (clear and cool) day generally creates a better draft in the chimney than a low-pressure (overcast and damp) day.
PAGE 18
PARTS, ACCESSORIES AND OPTIONS LIST (Options and trim (i.e. brass and nickel) interchange for variety.) REPLACEMENT PARTS AC-G17 AC-GGK AC-DGKNC AC-PGK AC-SB AC-SBN AC-SB2 AC-SBN AC-13BTF AC-13BTM AC-13BTR AC-13CFB AC-SH AC-SHN AC-SH4 AC-SH4N AC-MBSP DOOR GLASS KIT WITH GASKET (16 ½ “ x 9 ¼ “ x .
PAGE 19
You may write your unit’s Manufacture Date and Serial Number in the blank spaces on this sample tag, for future reference. This sample tag also shows the safety info. such as UL testing standard, etc. for your local officials, or anyone else who may need reference information.
PAGE 20
Have this information on hand if you phone the factory or your dealer regarding this product. Retain for your files: Model Number __________________________ Date of Purchase ________________________ Date of Manufacture _________________ Serial #_____________________ LIMITED 5 YEAR WARRANTY FROM THE DATE OF PURCHASE TO THE ORIGINAL OWNER The manufacturer extends the following warranties: Five Year Period: 1. Carbon steel and welded seams in the firebox are covered for 5 years against splitting. 2.
PAGE 21
WARRANTY REGISTRATION for England’s Stove Works Purchased by (Name) ______________________________________________ Address _________________________________________________________ City ________________________ State __________ Zip _________________ Telephone _______________________________________________________ Email Address ___________________________________________________ DEALER INFORMATION Purchased From (Dealer) ___________________________________________ Address __________________________________