Owner's Manual

ManualsBrandsEngland's Stove Works ManualsStoveEngland's Stove Works 25-PAF

INSTALLATION AND OPERATION MANUAL

25-PAF, 55-SHP25 AND 55-TRP25

Thank you for purchasing this product from a fine line of heating equipment.

We wish you many years of safe heating pleasure.

NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO

THE DEALER. CONTACT CUSTOMER SERVICE @ 1-800-245-6489.

Save these Instructions.

Please Note the Following Precautionary Statements:

WE DO NOT RECOMMEND PELLET UNITS AS YOUR ONLY SOURCE OF HEAT.

This unit is designed as an Add-On Furnace, to supplement your existing system.

It is not designed to heat your home from a cold start.

NOTE: THIS STOVE IS NOT MOBILE HOME APPROVED

CAUTION: These units must be installed in accordance with these instructions and

comply with your local building and fire codes. Please read this entire manual before

installation and use of this pellet fuel burning add-on furnace.

Keep children, furniture, fixtures and all combustibles away from any heating appliance.

WARNING: USE OF OUTSIDE AIR IS MANDATORY WITH THIS UNIT.

DO NOT OPERATE UNIT WITH HOPPER OPEN. LID MUST BE SHUT AND SECURED TIGHTLY.

DO NOT OPERATE WITH DOOR OPEN, OPEN DOOR ONLY WHEN LIGHTING.

→SAFETY NOTICE←

FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY

DAMAGE, BODILY INJURY OR EVEN DEATH. FOR YOUR SAFETY AND PROTECTION,

FOLLOW ALL THE INSTALLATION INSTRUCTIONS. CONTACT YOUR LOCAL

BUILDING OR FIRE OFFICIALS FOR RESTRICTIONS AND INSTALLATION

INSPECTIONS IN YOUR AREA.

Rev. 1/06

England’s Stove Works highly recommends the use of smoke detectors and

Carbon Monoxide detectors with any hearth product, including this unit. Follow all

manufacturer’s instructions when using smoke or Carbon Monoxide detectors.

Summary of content (19 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL 25-PAF, 55-SHP25 AND 55-TRP25 Thank you for purchasing this product from a fine line of heating equipment. We wish you many years of safe heating pleasure. NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO THE DEALER. CONTACT CUSTOMER SERVICE @ 1-800-245-6489. Save these Instructions. Please Note the Following Precautionary Statements: WE DO NOT RECOMMEND PELLET UNITS AS YOUR ONLY SOURCE OF HEAT.
PAGE 2
A letter from our Technical Support department: Thank you for purchasing this fine product from England’s Stove Works! England's Stove Works was started, and is still owned by, a family that believes strongly in a "Do It Yourself" spirit – that’s one reason you found this product at your favorite “Do It Yourself” store.
PAGE 3
IMPORTANT INFORMATION 1. Check local installation codes for your area. 2. Read and comply with the instructions in this manual. 3. This unit should be tested (dry run) before loading pellets. 4. Your stove is designed to burn Premium Hardwood Pellets. Pellets with a high ash content will burn dirty and the unit will need cleaning more frequently. 5. Be sure your pellets are not damp or wet. Keep sawdust out of the unit. 6.
PAGE 4
Some dealers will prepare your unit for operation and even “dry run” it before delivery. If this has not been done, you can follow the steps as listed below. 1. Attach the spring handle to the door by turning it counterclockwise. Install the hopper lid latches as illustrated by the drawing at the rear of this manual. Important: Latches must be tight so that the top is sealed to prevent back-burn. Check to insure the baffle is in place in the firebox. 2.
PAGE 5
A wall strap should be placed just below the last 90-degree section to make the system more stable. If you live in an area that has heavy snowfall it is recommended the installation be taller than three feet (3’) to get above the snow drift line. This same installation can be used if your stove is below ground level by simply adding the clean-out section and vertical pipe inside until ground level is reached. With this installation you have to be aware of the snowdrift line, dead grass and leaves.
PAGE 6
Wall Protection From the rear and sides of this stove only six inches (6”) of clearance is required to paneling, wallpaper or sheet rock. The pellet vent pipe would require the standard three inches (3”) clearance as recommended by the manufacturer. Normally additional wall protection is not required with this type unit. OPERATING INSTRUCTIONS CAUTION: Do not operate with the door open; open door only when lighting.
PAGE 7
room air blower will stop operating; the exhaust blower and the bottom auger will cease to operate when the temperature drops to 90 degrees. The red light will now shut off and the unit will be completely down. Keep in mind that the hotter the unit is operating, the longer it will take for the stove to complete the shut down cycle. Note: If the room temperature stays above 70 degrees, the unit will remain in the shut down mode for 54 minutes, regardless of the temperature at the heat sensor.
PAGE 8
Weekly Ash Removal Shut the unit down by pressing the “OFF” pad and allowing the unit to go through the complete shut down cycle. Allow the unit to completely cool down and then remove the ashes by pushing them into the ash pan and dumping them. {NOTE: The 3” x 9” Ash Dump Door (the flat, rectangular piece of steel with a handle that is located directly above the ash pan) must be pulled out so the ashes from the burn pot area can be dropped into the ash pan.
PAGE 9
Auger Bearings and Auger Shafts The auger bearings (PART #PU-UCF204-12) are a sealed unit and do not require lubrication. To replace the top auger all the fuel must be removed from the hopper, as well as the top auger motor assembly (see above). Once this is done the four bolts that hold in the bearings can be removed. At this time, the complete auger assembly can be pulled from the stove. Loosen the two (2) set screws with a 9/64” allen wrench, which will disconnect the bearing from the shaft.
PAGE 10
THE FUNCTION OF THE ADD-ON FURNACE The Add-On Furnace is designed to be a supplemental hot air heating system that will connect to your existing heating system. The furnace will operate independently of your existing system while using the same hot air ducts that your present furnace uses. The furnace comes standard with a 850 CFM blower that pushes hot air up both sides and across the top of the unit through an inner-duct chamber built around the firebox.
PAGE 11
Installation Notes Flashing 12” Min. (Use End Cap) 3” Min. Clearance 3” Min. Outside Air Inlet: Use 1 7/8” I.D. Pipe (see manual) NOTE: 1. 2. 3. 4. 5. If 3” flue pipe exceeds 15’ in length, increase to 4” flue pipe for remaining flue connections. Total flue length should not exceed 35’. Horizontal run not to exceed 4’. Floor protector required: Min. size 36” x 36”. Outside Air is Mandatory. 3” Min.
PAGE 12
Low Burn: Medium Low: Medium High: High Burn: Recommended Heat Ranges: Heat Range setting: 1 Room Air Blower setting: Heat Range setting: 2 – 3 Room Air Blower setting: Heat Range setting: 5 – 8 Room Air Blower setting: Heat Range setting: 9 Room Air Blower setting: * NOTE: Blower Speed should match Heat Range. CAUTION: NOTE: The bottom 3 buttons are pre-set at the factory and do not need adjustment. Call Service at (800) 245-6489 if you have questions or problems.
PAGE 13
THE CONTROL BOARD The control board (PART #PU-CB98) is a digital read-out board. This board offers a wide variety of settings to operate the unit. Again, the bottom controls are preset at the factory and should not require any alteration on start-up of the unit (see “Unit Preparation” section for information on setting the Heat Range). This part can be removed from the unit by loosening the two screws on the outside of the stove, and then pulling it back to the inside of the stove.
PAGE 14
Have this information on hand if you phone the factory or your dealer regarding this product. Retain for your files: Model Number __________________________ Date of Purchase ________________________ Date of Manufacture _________________ Serial #_____________________ LIMITED 5 YEAR WARRANTY FROM THE DATE OF PURCHASE TO THE ORIGINAL OWNER The manufacturer extends the following warranties: Five Year Period: 1. Carbon steel and welded seams in the firebox are covered for 5 years against splitting. 2.
PAGE 15
ACCESSORIES and REPLACEMENT PARTS LIST FOR 25-PAF, 55-SHP25 and 55-TRP25 OPTIONS: AC-3000 3” PELLET VENT KIT AC-3001 REMOTE THERMOSTAT AC-106-P/SH-106-P BRASS WINDOW TRIM AC-103 BRASS LIP TRIM FOR ASH APRON GU-1E30-914 WALL THERMOSTAT REPLACEMENT PARTS: AC-GGK GLASS GASKET KIT AC-DGKC DOOR GASKET KIT AC-G9 9” X 9” CERAMIC GLASS (W/GASKET) AC-SH DOOR SPRING HANDLE AC-MCSP HI-TEMPERATURE CHARCOAL PAINT PU-047040 1 R.P.M.
PAGE 16
Pellet Stove Exploded View
PAGE 17
TROUBLE-SHOOTING GUIDE WARNING: TO AVOID ELECTRICAL SHOCK ALWAYS DISCONNECT THE UNIT FROM THE POWER SOURCE BEFORE ATTEMPTING ANY REPAIR. IF THIS GUIDE DOES NOT CORRECT THE PROBLEM CALL YOUR LOCAL DEALER OR CUSTOMER SERVICE AT 1-800-245-6489. . Cause Solution Problem 1. Auger not turning 1. Loose set screw 2. Bad gear motor 3. Foreign matter in auger 4. Vacuum sensor (Top Auger) 1. Tighten setscrew on collar 2. Replace auger motor 3. Remove pellets and object 4. Check exhaust blower 2.
PAGE 18
PAGE 19
WARRANTY REGISTRATION Purchased by (Name) ______________________________________________ Address _________________________________________________________ City ________________________ State __________ Zip _________________ Telephone _______________________________________________________ Email (Optional) ___________________________________________________ DEALER INFORMATION Purchased From (Dealer) ___________________________________________ Address _________________________________________________________