Owner's Manual

COMPONENTREPLACEMENT,CONTINUED

Augermotor/Augercontinued

Loosenandremovethetwo½”boltsholdingtheaugermotorsupportshelf,thenremovethe

assembly.Youwillneeda5/16”sockettoremovethetwoscrewsthatholdtheaugermotorto

thesupportshelf(fromthebackside).Thenremovethecotterpinthatholdstheaugerto

the

augermotor.Toremovetheaugerfromthesupportshelf,simplyslideitout.Toreinstallthis

assembly,slidetheaugerin,connectittothemotorusingthecotterpin,reinstallthetwo

5/16”screwsthroughtheshelfandmotor,andslidetheassembly(augerfirst)backinand

reinstallthetwo½”bolts.



Hopperlidlatches

Toadjustthelidlatch,thefollowingtoolswillbeneeded:two,½”wrenches(orawrenchanda

socket).Inordertoadjustthelatch,firstopenthehopperlidandthenlockthelatchinits

closedposition.Thentakethe½”wrenchandloosenthenutclosesttothelatch(seebelow).

Thisnutisthenadjustedclosertotheliditselftotightenthelatch.Afteradjustingthisnutto

thedesiredlocation,holdthisnutinplacewiththe½”wrench,thentightendowntheholding

nutontheendofthelatchshaftwiththe½”socketorsecondwrench,toholdthelatching

assemblyinplace.Aftertighteningthelatch,testthelatchforpropertensionbylockingthelid

downandliftingeachfrontcornerofthelid.Thelidshouldbefirmlyhelddownbythelatch.

Toreplacethelatch,removethe5/16”screwfromthebracket,usingasocketorwrench.

Removethelatchandreplacewithanewone,andreinstallthe5/16”screwandbracket.