Installation Guide

3. Side Heat Shields

This accessory item

comes with the hardware

(six (6) mounting screws)

necessary to install it on

the rear of the stove. This

is a two-piece heat shield,

but is installed one piece at

a time. There are pre-

punched holes on each

side of the Rear Heat

Shield; while holding each

piece of the Side Heat

Shield in place, align the

pre-punched holes in the

Side Heat Shield with the

existing holes in the Rear

Heat Shield, and fasten

with the screws provided.

See Illustration 1 for

clearances with and without

side heat shields.

Rear Heat Shield

Side

Heat

Shield

Side

Heat

Shield

Illustration 3 – Side Heat Shield and Blower Installation

Install AC-16 Optional

Blower on these (4) mounting

holes. See “Optional Blower

Instructions” on page 4 for

instructions.

Illustration 4

BRICK LAYOUT

1 – 9” x 4” x 1.25” brick (Qty. 11)

3 – 4” x 2.5” x 1.25” brick (Qty. 1)

5 – 4” x 4.5” x 1.25” brick (Qty. 1)

7 – 9” x 2.5” x 1.25” brick (Qty. 2)

2 – 9” x 4” x 1.25” brick w/ .75 x .75 notch (Qty. 2)

4 – 4.5” x 4” metal plate (Ash Drawer Plate, Qty. 1)

6 – 9” x 4” x 1.25” brick w/ 1” x 3” notch (Qty. 1)