Use and Care Manual

45

IMPORTANT!READANDFOLLOWALLINSTALLATIONANDMAINTENANCEINSTRUCTIONS,INCLUDINGCLEANINGTHEUNITASSPECIFIED,AND

REPLACINGGASKETSANNUALLY,ANDPARTSASNEEDED.

ENGLAND’SSTOVEWORKSISNOTRESPONSIBLEFORANYDAMAGEORINJURYINCURREDDUETONEGLECT,ORDUETOUNSAFEINSTALLATIONOR

USAGEOFTHISPRODUCT.CALLTECHNICALSUPPORTWITHANYQUESTIONS.



 Whenplacingtheaugerassemblyintheunit,alwaystightenthefouraugerbearingboltsina

diagonal(criss‐cross)patterntoensurethebearingsandshaftsarealignedproperly.

Remembertoinstalltheaugershelfsupport,placingthetwobottomboltsthroughtheshelf

andtheaugerbearing.



NOTE:Followthesameproceduretoworkonthebottomauger,withtheexceptionthatthe

pelletsdonotnecessarilyhavetoberemovedfromthehopper.

 Visityoutube.com/heatredefinedfordetailedservice‘howto’videos.



Combustion(Exhaust)Blower

 Beforebeginninganycomponentreplacement,becertaintheunitisunpluggedand

thoroughlycooleddown.

 Disconnectthepelletventpipesothatthecombustionblowermaybeaccessed.

 Removetheleftsideaccesspanel,using a5/16”wrench..

 Removethebackpaneloftheunit,usinga

5/16”wrench.

 Disconnectthepowerleadstothecombustionblower.

 Removeall (5) screwswhichholdtheexhaustblowertotheexhaustblowertube.Oncethe

screwshavebeenremoved,theblowercanbeliftedupandoutofthestove.

 Replacethecombustionblowergasketeach

timeyouremovetheblowerfromthestove

(Part#PU‐CBMG).

Removethegasketwithaputtyknife,andinstallthenewgasketby

applyingadhesivetotheblowerflangeandinstallingthenewgasket(instructionsand

adhesiveareprovidedwiththegasket).

 Reinstallationistheexactoppositeofthestepsabove.

 Visityoutube.com/heatredefinedfordetailedservice‘howto’videos.







Combustion

(Exhaust)Blower