Use and Care Manual

ACCESSORY ITEMS

The following accessories can be added to your unit at anytime after purchase; however, let the

unit cool down before adding any accessories.

Thermostats

WALL: An external wall thermostat (such as our Part # GU-1E30-914) can be used on our

pellet units as long as it is a low-voltage that works with millivolt systems. After unplugging the unit,

locate the jumper wire (J-3) on the bottom of the control panel. The two screws should then be

loosened and the jumper wire removed from the board. Next, the two thermostat lead wires should

be slipped into these openings and the screws tightened; the jumper wire should be saved for future

operation without a thermostat.

The unit will operate differently once the wall thermostat is connected – we recommend the

Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat. Refer to

the section on “Start-up Procedure” for information on cold starts.

AC-103, AC-103BN Lip Trim

There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the stove.

Match the channel with the correct edge of the ash apron, then remove the protective covering from

the trim and force the piece onto the edge. Although it should stay in place, stove cement can be

used to secure it if necessary.

NOTE: For stoves manufactured prior to 2001, the part number for this kit is AC-101-PU.

AC-106-P (SH-106-P), AC-106-PBN Window Trim

Window trim can be attached by using the provided spring clip(s) and some high temperature

silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim –

then, turn the clip and set the other end of the clip into the channel. The spring clip will hold well if it

is placed on the top edge of the trim before placing the trim in the window of the stove. Place the

top edge with the clip into the window opening, then push the bottom edge of the trim flush with the

window. We also suggest that high temperature silicone be used on the corners, to ensure the trim

will stay in place.

Accessories can be ordered from the factory at:

(Parts orders ONLY) -- (800) 516-3636, or on our web site: www.englanderstoves.com

Questions/Problems: Please call Technical Support at (800) 245-6489.

You may also order parts and options, view frequently asked questions and more,

on our web site: