Use and Care Manual

ManualsBrandsEnglander ManualsHeating, Ventilation, and Air Conditioning3,000 sq. ft. Wood-Burning Add-On Furnace

INSTALLATION AND OPERATION MANUAL

MODELS: 28-3500 , 50-SHW35 & 50-TRW35

WOOD ADD-ON FURNACE

Thank you for purchasing this product from a fine line of heating equipment.

Please read this manual before attempting to move or install your unit.

We wish you many years of safe heating pleasure with your new heating appliance.

Visit our web site at www.englanderstoves.com

for helpful information, frequently asked

questions, parts & accessory orders and more.

Please Note the Following Precautionary Statements:

CAUTION:

This unit must be installed in accordance with these instructions and must comply with local

building and fire codes. Failure to do so could result in a chimney or house fire.

Keep children, furniture, fixtures and all combustible materials away from any heating appliance.

Maintain a minimum clearance of 18” (18 inches) from the flue pipe to any combustibles. Refer

to information in this manual and on the unit, and to all pipe manufacturers’ instructions.

This unit is not mobile home approved.

Do not install this unit in a mobile home!

READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING THIS MODEL.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED INSTALLER.

NOTE:

IF YOU HAVE A PROBLEM WITH THIS UNIT, DO NOT RETURN IT TO THE

DEALER. PLEASE CONTACT CUSTOMER SERVICE at (800) 245-6489.

FUEL: WOOD

HEATING CAPACITY: Approx. 3,000 SQ. FT (when fed into existing ductwork)

TESTED TO: UL 391, CSA-B366.1, ETLM 78.1

Rev: 8/2010

England’s Stove Works highly recommends the use of smoke detectors and Carbon

Monoxide detectors with any hearth product, including this unit. Follow all manufacturer’s

instructions when using smoke and Carbon Monoxide detectors.

Summary of content (19 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL MODELS: 28-3500 , 50-SHW35 & 50-TRW35 WOOD ADD-ON FURNACE Thank you for purchasing this product from a fine line of heating equipment. Please read this manual before attempting to move or install your unit. We wish you many years of safe heating pleasure with your new heating appliance. Visit our web site at www.englanderstoves.com for helpful information, frequently asked questions, parts & accessory orders and more.
PAGE 2
A letter from our Technical Support department: Thank you for purchasing this fine product from England’s Stove Works! England's Stove Works was started, and is still owned by, a family that believes strongly in a "Do It Yourself" spirit – that’s one reason you found this product at your favorite “Do It Yourself” store.
PAGE 3
SAFETY NOTICE IF THIS UNIT IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY AND PROTECTION, FOLLOW ALL OF THE INSTALLATION INSTRUCTIONS. INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED INSTALLER. CONTACT YOUR LOCAL BUILDING OR FIRE OFFICIALS FOR RESTRICTIONS AND INSTALLATION INSPECTIONS REQUIRED IN YOUR AREA. IMPORTANT: DO NOT OVER-FIRE. SEE “DO NOT OVER-FIRE YOUR UNIT” IN THE “OPERATING INSTRUCTIONS” SECTION. CAUTION – Hot Surfaces: Keep children away. Do not touch during operation.
PAGE 4
C: Installation of a New Flue System 1. Masonry Flue: If you are considering a masonry flue (see Figure 1), you should contact your local building officials for the proper procedures required in the construction. We recommend that you consult with and have your flue built by a licensed, bonded contractor. Most masonry flues are placed against the outside wall and extend up the side of the house.
PAGE 5
Installation Diagrams and Thermostat Wiring 18” Min. 18” Min. 18” Min. Figure 2 – Installation into a HT Pipe Flue System. LEFT – Through the Roof RIGHT – Through the Wall IMPORTANT NOTE: Do NOT connect this furnace to an external thermostat. Figure 1 – Installation into a Masonry Flue NOTE: 13” required from back of unit to a combustible. 16” required from sides of unit to a combustible. See Floor and Wall Protection sections and data label on stove for all clearances.
PAGE 6
SECTION II: FLOOR AND WALL PROTECTION A. Floor Protection There is no protection required if your floor is constructed of a noncombustible material such as concrete. If your floor is constructed of a combustible material such as hardwood, carpet or linoleum some type of floor protection will be required. When selecting the required floor protection it is important that you install a U.L. approved board.
PAGE 7
Chimney Connector Pipe This black pipe must be 6” (6 inches) in diameter and a 24-gauge or heavier pipe. Do not use aluminum or galvanized steel, as they cannot withstand the high temperatures of a wood fire. Do not use single wall pipe as a chimney. You must connect your stove to a chimney comparable to those illustrated in this manual. The chimney connector pipe lengths must be attached to the stove, and to each other, with the crimped end toward the stove.
PAGE 8
less expensive than a complete section of cast iron grate, and the brick will hold more heat and make your wood last longer as it burns. SECTION V: HOT AIR HOOK-UP (See Fig. 3) NOTE: The warm air supply-duct system should be constructed of materials with a minimum temperature rating of 250 deg. F. Also, the plenums installed to the furnaces are to be constructed of metal.
PAGE 9
B. Thermostat Installation The thermostat, blower and power cord are all prewired (see Figure 4 for thermostat instructions); however, the thermostat must be connected to the furnace after installation of the blower. Do this by inserting the probe portion into the stove (remove the cover first, to reveal the mounting plate) and fastening the thermostat to the unit with the four screws that are mounted on the furnace.
PAGE 10
Notice: The surface of your new furnace and the connector pipe may smoke for a short time, and this is no cause for alarm. This is called “cooking out,” and it is advisable to open doors and windows in your dwelling during the first two hours (approximately) of operation. 1. Place several pieces of crushed paper evenly over the entire bottom of the firebox and lay small dry sticks of kindling on top of the paper. 2.
PAGE 11
B. Draft Controls This unit has a draft control system that is used to determine the amount of combustion air that enters the stove. The more the controls are opened, the more air will enter the firebox and thereby increase the heat output of the unit. This will, by creating a hotter fire, make your fuel burn faster. Pushing the slide draft located above the door to the left opens the damper, and unscrewing the bottom screw damper (counterclockwise) located on the bottom ash door opens that control.
PAGE 12
3. Use a poker to rake the dead ashes through the grates into the ash pan. Be sure to leave some “live” ashes in the firebox. 4. Fill the firebox with dry seasoned wood and leave the door cracked approximately 1/2” (one-half inch). Allow the fire to burn in this manner for 15 to 20 minutes. 5. Close the door completely, leaving both draft controls in the open position, and allow the furnace to burn in this manner for another 5 to 10 minutes. 6.
PAGE 13
SECTION VIII: CARE AND MAINTENANCE (Unit must be cool and power unplugged before performing any maintenance) A. Gaskets Refer to the list at the rear of this manual for part numbers. You may order parts by calling (800) 516-3636 or logging on to www.englanderstoves.com . Each unit comes with a rope gasket around the door, which should be replaced at least every two years. To replace the gasket, the old gasket material should be removed and the door channel scraped free of any adhesive.
PAGE 14
E. Baffle Plate This furnace has a large baffle plate (Part IP-2835) that is located in the top of the firebox. This baffle plate lays on an angle iron track and can be removed by sliding it out of the unit. If the baffle becomes warped, it can be replaced by calling (800) 516-3636 or logging on to: www.englanderstoves.com . Caution: Allow the furnace to cool down before removing the baffle plate or performing any maintenance.
PAGE 15
You may write your unit’s Manufacture Date and Serial Number in the blank spaces on this sample tag, for future reference. This sample tag also shows the safety info. such as UL testing standard, etc. for your local officials, or anyone else who may need reference information.
PAGE 16
LIMITED 5 YEAR WARRANTY FROM THE DATE OF PURCHASE TO THE ORIGINAL OWNER The manufacturer extends the following warranties: Five Year Period: 1. Carbon steel and welded seams in the firebox are covered for 5 years against splitting. 2. The cast iron door, hasp and hinges are covered for 5 years against cracking. One Year Period: 3.
PAGE 17
ADD-ON FURNACE PARTS / OPTIONS LIST (Check your model for paint color, trim color, etc. if ordering a replacement for an original part). AC-G9 GLASS (9” X 9”), with Gasket AC-GGK GLASS GASKET KIT (gasket only, no glass) AC-MBSP BLACK SPRAY PAINT AC-1339 THERMOSTAT AC-DGKC DOOR GASKET KIT AC-FCGK FLUE COLLAR GASKET KIT AC-SB FIREBRICK (9”X4”X1 ¼”) (21 qty.) AC-SB7.75 FIREBRICK (7.75”X4”X1 ¼”) (5 qty.
PAGE 18
PAGE 19
WARRANTY REGISTRATION for England’s Stove Works Purchased by (Name) ______________________________________________ Address _________________________________________________________ City ________________________ State __________ Zip _________________ Telephone _______________________________________________________ Email Address ___________________________________________________ DEALER INFORMATION Purchased From (Dealer) ___________________________________________ Address ___________________________________