Manualshelf

Use and Care Manual

ManualsBrandsEnglander ManualsHeating, Ventilation, and Air Conditioning3,000 sq. ft. Wood-Burning Add-On Furnace
12345678910
9
B. Thermostat Installation
The thermostat, blower and power cord are all prewired (see Figure 4 for
thermostat instructions); however, the thermostat must be connected to
the furnace after installation of the blower. Do this by inserting the probe
portion into the stove (remove the cover first, to reveal the mounting plate)
and fastening the thermostat to the unit with the four screws that are
mounted on the furnace. Refer to the following illustraton:
SECTION VII: OPERATING INSTRUCTIONS
A. Building a Fire
NOTICE: Do not operate unit with bottom (ash) door open.
Operating unit with ash door open can cause over-firing and damage
the unit, and will void any warranty.
Except as specified in “Operating Instructions,” do not operate unit
with fuel (main) door open.
BURN WOOD ONLY
CAUTION: Do not elevate the fire. Build fire directly on the floor of the unit.
Probe thermostat mounts in top rear
(
4 screws
)
Blower mounts on bottom rear
(5 screws)