Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
#B #A x 8pcs #B x 8pcs #1 #I #A #5 #4 #1 Insert barrel nuts (#B) to the holes of the side rails (#4,5). Align the side rails (#4,5) to the holes of the lower end guardrail (#1). Secure by connecting bolts (#A) with the barrel nuts (#B). 1) Insert wood dowels to each end of the holes of back and front #B guardrails (#8,9). Insert barrel nuts (#B) to the guardrails (#8,9), then align the guardrails (#8,9) to the holes of the upper end guardrails (#2,3).
#8 #D #10 #I #D x 9pcs #10 #9 #7 #10 #6 Align guardrails (#10) to the holes of the side rails (#8,9), then secure with screws (#D). Insert metal dowels (#G) onto the top holes of the lower end guardrails (#1), then carefully align and place the upper end guardrails (#2,3) through the metal dowels (#G).
Align ladder rung (#13) to the holes of the ladder rails (#11,12), then secure with screws (#E). #11 #E x 8pcs #E #13 #12 #I #E Insert wood dowels (#F) onto the holes of the ladder, then align the ladder to the holes of the side rails of the bed frame as shown in the picture. Secure with bolts (#C).
Align slats kit (#14) to the side rails of the bunk bed, then secure with screws (#H).
Safety Warnings for Bunk Beds 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Read and follow the information on the WARNINGS shown on the end structure of the upper bunk and on the carton. Do not remove warning label from the bed. Keep these instructions for future reference. Always use the recommended size mattress or mattress support, or both, to help prevent the likelihood of entrapment or falls. IMPORTANT: Must use Bunkie mattress.
