Owner`s manual

ELECTRICAL REQUIREMENTS

AND INSTALLATION

The following information is provided for hooking up electrical supply to

yournewspa.Aqualied,licensed,electricianmustperformthiswork.

Failure to follow these instructions will terminate all warranty coverage

and can cause serious injury or death.

Your Allegro spa is preset at the factory to run on 240V with a 48 amp

input. This feature gives you the most performance out of your spa.

This will require a 240V, 60-amp GFCI. If a 60-amp service is not avail-

able.

The Allegro spas may also be setup to run off of 120VAC. See page

14 for conversion information.

ELECTRICAL WIRING FOR 240VAC SETUP

WARNING: Your spa must be wired by a certied electrician and

according to these instructions. Failure to do so will terminate all

warranties and all listings from the independant listing facility.

1) The Platinum Class Spa requires a 240 VAC dedicated

system. The spa must be hardwired to the power supply, with no

plug-in connections, extension cords, or sharing of service.

2) The spa requires that you run 6 or 8 AWG copper wire, depending

on the GFCI size. Do Not Use Aluminum Wire.

3) The power supply must have a suitable Ground Fault Circuit

Interrupter (GFCI), according to Section 422-20 of the National

Electrical Code, ANSI/NFPA 70-7987. This could be used as the

shut-off switch, which must be installed in plain view of the spa. This

electrical service must be readily accessible to the spa occupants,

but must not be within 5 feet of the spa.

4)Useonlynon-metallicconduitandttingswheninstallingpowerto 

the spa.

5) After your spa has been positioned, route lines through the knockout

on the left or right front corner of the spa.