Owner`s manual

SPA START-UP cont...

TESTING THE GFCI BREAKER cont...

NOTE: When power is turned on, your spa is automatically

programmed to start circulating water for 5 minutes. Adjust your

temperature by pressing the “Warm” button on your touchpad

until the desired temperature is displayed. This setting will allow

your spa to heat to the set temperature.

CAUTION: If water is not noticeably coming from your spa jets

during the automatic purge, turn on the high speed pump. If water

is still not coming from the jets, the pump needs to be manually

primed, following the steps below.

PRIMING THE PUMP

1) Turn off power at electrical service panel.

2) Locate and loosen the pump by turning it counterclockwise one half

of one turn.

3)Allowairtoescapefromthetting.Whenasteadystreamofwater 

owsfromthepumpplug,closeitbyturningitclockwiseuntiltight.

4) Turn on power at electrical service panel.

5)Checkoncemoretomakesurethatwaterisowingfromthejets 

during auto purge. If so, continue. If no water is coming from your

spa jets, please call your Artesian dealer for further assistance.

WATER PREPARATION

NOTE: Before putting your new spa into operation, understand

that preparing your new water is an important part of

maintenance. Failure to properly prepare your water can result

in substantially decreasing the life of the components and may

void your warranty in severe cases. Your Artesian dealer should

have a start-up and maintenance kit available for you when you

receive your spa.