Owner`s manual

24
Diagnostic Messages cont...
Sensors are out of balance. If alternating with spa
temperature, it may just be a temporary condition. If
flashing by itself, spa is shut down.
If the problem persists, contact your dealer or
service organization.
A significant difference between temperature sensors has
been detected. This could indicate a flow problem.
Check water level in spa. Refill if necessary. If the water level
is okay, make sure the pumps have been primed. If problem
persists, contact your dealer or service organization.
Persistent low flow problems. (Displays on the fifth
occurrence of “ ” message within 24 hours.) Heater is shut
down, but other spa functions continue to run normally.
Follow action required for “ ” message. Heating capability
of the spa will not reset automatically; you may press any
button to reset.
Possible inadequate water, poor flow, or air bubbles in
detected in the heater. Spa is shut down for 15 minutes.
Check water level in spa. Refill if necessary. If water level is
okay, make sure the pumps have been primed. Press any
button to reset, or this message will automatically reset
within 15 minutes. If problem persists, contact your dealer
or service organization.